Help information

Costing of Multipanels

The minimum area of PCBs which can be ordered is 1 dm²

Where there are boards which are smaller than 1 dm(2) we will automatically produce as many pcbs that fit within this area. If a rout charge is paid, we can deliver these as single units. If the boards should be delivered as one piece, then only one pcb outline should be supplied. As an alternative you can instruct us to deliver a panel with the boards held on pips. ( Extra charge ) The routing and soldermask charge will only be applied once in this case.







Mixed Multipanels with boards < and > 1 dm²

If your multipanel is mixed with boards both larger and smaller than 1 dm² they will be split up and produced and invoiced separately.
The board(s) which are greater than one square decimeter will be charged individually and a soldermask and rout charge ( where applicable ) will apply in each case. The board(s) which are smaller will be put together and one soldermask charge and one rout charge will apply.





Panel with boards held on pips for printed circuit boards ≤ 20 mm x 20 mm

For reasons of quality assurance, printed circuit boards ≤ 20mm x 20 mm are manufactured and delivered on a panel (printed circuit board holder).
No additional costs are involved here (Break-off pips routing charge).